This steel optic mount adapts S&W M&P C.O.R.E. slides for direct-mounting Aimpoint ACRO P-1/P-2, Steiner MPS, and Lead & Steel Pandora PB-3 optics. Billet steel construction replaces polymer factory plates to eliminate flex under recoil and prevent zero shift. Black oxide finish resists holster wear and corrosion. An integrated maintenance window allows extractor pin removal without dismounting the optic – no need to re-zero after slide work.
Compatibility
- S&W M&P Classic C.O.R.E. (9mm, .40, .45)
- S&W M&P M2.0 C.O.R.E. (all calibers)
- Will not fit non-C.O.R.E. slides or Shield/Compact models without C.O.R.E. cut
Key Features
- Material: machined billet steel, black oxide finish
- Optics supported: Aimpoint ACRO P-1, ACRO P-2, Steiner MPS, Lead & Steel Pandora PB-3
- Maintenance window: access extractor pin without removing mount
- Mounting screws included
- Torque spec: 15 in-lb (recommended)
- Manufactured in Arizona, USA
Install Difficulty: 2/5
Requires: 3/32” hex driver, torque wrench (inch-lb), blue Loctite. Clean slide surface before install. Remove factory C.O.R.E. plate, position mount, apply thread locker, torque screws to 15 in-lb. Expect 10–15 minutes.
FAQ
Will this mount work on a non-C.O.R.E. M&P slide?
No. This mount is cut specifically for S&W C.O.R.E. footprint slides. Non-C.O.R.E. slides require slide milling before use.
Can I remove the optic without losing zero on the mount?
Yes. The mount is fixed to the slide via four screws. The optic attaches to the mount independently. Removing the optic does not disturb mount-to-slide interface.
Does this mount fit the ACRO P-2 with the factory killflash?
Yes. The mount deck is designed to clear ACRO P-2 body dimensions including the factory killflash. No modification required.
Ships same business day if ordered by 2 PM ET. Backed by manufacturer warranty against defects in material and workmanship. Returnable within 30 days of delivery if unused and in original packaging.
Reviews
There are no reviews yet.