Flat-Faced Forward Set Sear & Trigger Kit for M&P

This is the Flat-Faced Forward Set Sear & Trigger Kit for the Smith & Wesson M&P series. It addresses the primary complaint of factory striker triggers—a long, gritty pull with excessive over-travel and a vague reset. By replacing the sear housing block and trigger mechanism, this kit converts the M&P’s trigger cycle to one that mimics the short, crisp break and positive reset of a single-action 1911, while retaining the safety of a striker-fired duty pistol.

Compatibility

• Smith & Wesson M&P 9mm, .40 S&W, .357 SIG (full-size, compact, and Shield Plus NOT compatible)
• M&P 2.0 (all calibers)
• M&P 9L, M&P 9C (1.0)
• M&P 9 M2.0 Compact, 4.25″, 5″
• NOT compatible with M&P Shield, Shield Plus, M&P 22, or M&P 380

Key Features

• Reduces trigger pull weight to approximately 3.0–4.0 lbs (dependent on spring selection)
• Reduces overall trigger travel by ~40%
• Shortens pre-travel, over-travel, and reset distance
• Center-mounted pivoting safety maintains factory drop-safety values
• Flat-faced trigger shoe provides consistent finger placement for repeatable pulls
• Drop-in fit—no filing, stoning, or frame modifications required
• Includes sear, trigger, springs, and housing block

Install Difficulty: 3/5

Requires removal of the rear slide plate, striker assembly, and sear housing block. You will need a 1/16″ punch, a small hammer, and a bench block. Detailed video instructions are included via QR code in packaging. Average install time: 20–40 minutes.

FAQ

Does this kit work in the M&P 2.0 with the hinged trigger?

Yes. This kit replaces the entire trigger mechanism, including the trigger shoe and sear housing. The hinged trigger is removed entirely.

Can I use the factory trigger return spring with this kit?

Yes. The kit is designed to work with either the included Apex springs or the factory trigger return spring and sear spring, allowing you to adjust pull weight between ~3 lbs (competition) and ~4 lbs (duty/carry).

Does this kit reduce the trigger pull weight below 3 lbs?

No. The minimum safe pull weight with this component is approximately 3 lbs. Attempting to reduce it further by swapping springs or removing material may compromise the sear engagement and drop safety.

Shipping & Warranty: Ships same business day if ordered before 2 PM EST. This kit is covered by the manufacturer’s limited lifetime warranty against defects in materials and workmanship. No returns on installed triggers.